COOLER GP-CLEAN GAS INDUCTION 4355911 - Caterpillar

The Electronic Control Module (ECM) detects the following conditions:
The signal voltage from the intake manifold air temperature sensor is less than 0.2 Volts DC for more than eight seconds.
The ECM has been powered for at least two seconds.
Diagnostic code 0168-01 is not active.System Response:The ECM will use the default value of 70 °C (158°F) for the intake manifold air temperature. "Voltage Low" will be displayed next to the status for "Intake Manifold Air Temperature" on the electronic service tool.The cooling fan will operate at maximum speed.A warning will appear on the display on the control panel. The ECM will log the diagnostic code.Possible Performance Effect:
Poor stability
Poor cold running
White smoke
Black smoke
Poor acceleration under loadTroubleshooting:This fault can be caused by a sensor that is shorted to ground or a sensor that is internally shorted.Test Step 1. Perform the following diagnostic procedure: "Engine Temperature Sensor Open or Short Circuit - Test"Results:
OK - STOP