COOLER GP-ENGINE OIL 4695162 - Caterpillar

Illustration 13 g02618881
Press down key (14) until "Calibrations" is highlighted on the display screen.
Press OK key (15) .
Illustration 14 g02618883
Press down key (14) until "Vibe Motor Sol" is highlighted on the display screen.
Press OK key (15) .
Illustration 15 g02618886
Press OK key (15) to begin the calibration.
Illustration 16 g02618887
Verify that parking brake switch (2) is in the ON position.
Move throttle control switch (9) to the HIGH IDLE position twice. For each switch activation, hold the switch in this position for less than 1 second. The engine speed should increase to 2200 rpm.
Illustration 17 g02618888
Move vibratory switch (16) on the left instrument panel to the ON position.Note: The parking brake should be in the ON position during this operation.
Illustration 18 g02618889
Squeeze trigger (17), and move propel lever (1) to the FORWARD position.
Press OK key (15) .
Illustration 19 g02618890
Illustration 20 g02618891
Right Operator Control Station on AS2302C Screed
Illustration 21 g02618893
Right Operator Control Station on AS3301C Screed
Illustration 22 g02618895
Center Operator Control Station on AS4252C Screed
Rotate vibratory speed dial (18) on the screed operator station to the MINIMUM position.
Press OK key (15) .
Illustration 23 g02618899
Rotate vibratory speed dial (18) on the screed operator panel clockwise until the vibratory just begins to operate.
Press OK key (15) .
Illustration 24 g02619277
Rotate vibratory speed dial (18) on the screed operator panel clockwise until the speed of the vibratory shaft reaches 3000 300 rpm. Use Tool (A) to measure the speed.
Press OK key (15) .
Illustration 25 g02618900
The display should now read "CALIBRATION COMPLETE". Push back key (19) to return to calibration screen.Note: If the vibratory motor speed cannot be achieved during the calibration, replace the vibratory motor solenoid valve and retest.
Push home key (13) to exit the calibration screen.
Move propel lever (1) to the NEUTRAL position.
Move vibratory switch (16) on the left instrument panel to the OFF position.
Move throttle control switch (9) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (10) to the OFF position.
If the machine is equipped with an AS2302C Screed, hold plate in position, and replace two bolts (11) and washers.