COOLER 5343807 - Caterpillar

Illustration 7 g01280928
Remove screws (14). Remove top cover assembly (15).
Illustration 8 g01280965
Remove evaporator coil (16). Installation Procedure
Illustration 9 g01280965
Place evaporator coil (16) into position.
Illustration 10 g01281085
Illustration 11 g01281087
Remove screws (13) and blower motor (17). Remove screws (20) and actuator (19). Note: Blower motor (17) and actuator (19) need to be removed in order to facilitate easier alignment of doors (18) during the assembly of the top and bottom covers.
Illustration 12 g01281119
Illustration 13 g01281121
Illustration 14 g01281122
Install top cover assembly (15). Make sure that you align sensor wire (21) during the installation of top cover assembly (15).
Doors (18) must be aligned with top cover assembly (15).
Illustration 15 g01281128
Install screws (14) that retain top cover assembly (15).
Illustration 16 g01281156
Install blower motor (17). Install screws (13).
Illustration 17 g01281087
Install actuator (19) and screws (20).
Illustration 18 g01280893
Install duct assembly (11). Install bolts (10) and (12). Connect harness assembly (8). Install cable strap (9).
Illustration 19 g01280883
Connect sensors (6) and (7).
Illustration 20 g01280882
Install duct (5).
Illustration 21 g01280877
Install plate (4). Connect harness assemblies (1), (2), and (3). End By:
Remove the heating and air conditioning unit. Refer to Disassembly and Assembly, "Heating and Air Conditioning Unit - Install".