CORD AS 1881588 - Caterpillar

FCC Notice
The following notices are provided.Modification Statement
Caterpillar has not approved any changes or modifications to this device by the user. Any changes or modifications could void the users authority to operate the equipment.Interference
This device complies with Part 15 of the FCC Rules and Industry Canada license - exempt RSS standards. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Radiation Exposure
This device complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. RF Exposure guidelines can be found in Supplement C to OET65. The device also complies with RSS-102 of the IC radio frequency (RF) Exposure rules. Do not locate the transmitter near an antenna or operating with any other antenna or transmitter.FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. if the equipment is not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.Changes or modifications to this device without the express approval may void the users authority to use this device.CAN ICES-3 (B) / NMB (B)
This Class B digital apparatus complies with Canadian ICES-003.Simplified EU Declaration of Conformity/RED 2014/53/ EU Directive
This device has been evaluated against the essential requirements of the 2014/53/EU Directive.Radio Frequency Range
The following Driver Safety System communication device specifications are provided to aid in conducting any related hazard assessment and to ensure compliance with all local regulations:
Table 1
Bluetooth
Frequency Range: 2402–2480 MHz carrier frequencies
Maximum RF output power: +4dBm
Modulations: GFSK: π/4–DQPSK and 8DPSK
Channel Spacing: 1 MHz
Number of channels: 79
Channel bandwidth: 1 MHz for GFSK,
Type of Antenna: Brand Amotech part number: AL.A321C3 chip antenna/Gain 2.3dbi
Antenna gain: +2.3dBi Max Note: The DEA 500 radio can operate in Belgium without infringing on applicable requirements on the use of Belgiums radio spectrum.
Table 2
AM
Frequency Range: 531 kHz to 1602 kHz
Maximum RF output power: +/- 6dBi typical
Modulations: Amplitude modulation
Channel Spacing: 9kHz
Type of Antenna: