CORE GP-O CLR 0R3358 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 2P-2333 High Temperature Sealer -
B 207-1601 Rubber Lubricant 1
C - Loctite C5-A Copper Antiseize - Start By:
Remove the turbocharger.
Illustration 1 g02848918
Typical Example
The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
Loosen clamps (1) and remove bellows (2). Discard the clamps and bellows. Note: Refer to Special Instruction, REHS1728, "Application Guideline for the Bellows" for additional information on handling the bellows.
Remove elbow (5) and tube assembly (6). Discard the O-ring seals.
Remove locknuts (3) and exhaust manifold assembly (4). Discard locknuts (3).
Illustration 2 g02174076
Remove gaskets (8) and studs (7). Discard gaskets (8).
Illustration 3 g02848941
Typical Example
Separate manifolds (9) and (11) from manifold (10). Remove studs (12). Installation Procedure
Install exhaust manifold assembly (4) in the reverse order of removal.
Apply Tooling (A) to male ends of manifolds (9) and (11).
Apply Tooling (B) to male ends of tube assembly (6).
Apply Tooling (C) to studs (12) and (7). Tighten studs (12) and (7) to a torque of 35 5 N m (26 4 lb ft). The torque tool speed should not exceed 100 RPM.
Install gaskets (8) so that the tabs are down.
Install bellows (2) with the flow arrow pointing towards the exhaust cooler. Total misalignment of the bellows is 1.50 mm (0.060 inch) lateral and 1.50 mm (0.060 inch) axial.
Tighten clamp assemblies (1) to a torque of 7.5 1 N m (66 9 lb in).
Illustration 4 g01866113
Typical Example
Apply Tooling (C) to locknuts (3). Tighten locknuts (3) in the above sequence to a torque of 55 5 N m (41 4 lb ft).