CORE GP-O CLR 0R5549 - Caterpillar

Illustration 1 g03589602
Table 1
Specification for 292-1240 Exhaust Manifold Gp
Item Qty Part Specification Description
1 12 200-6554 Bellows As Allowable offset for the bellows assemblies from the center of the casting's inner diameter is 1.5 mm (0.06 inch).
2 48 9L-7373 High Temperature Bolt Before assembly, lubricate the threads with Loctite Nickel Anti Seize.
Tighten to 55 5 N m (41 4 lb ft).
Again tighten to 55 5 N m (41 4 lb ft).
3 108 8C-8491 Hard Washer Before assembly, lubricate the washer faces with Loctite Nickel Anti Seize.
Illustration 2 g03589603
View of area A
Table 2
Item Qty Part Specification Description
4 30 200-6556 Clamp Before assembly, lubricate the threads of bolts (5) with Loctite Nickel Anti Seize.
Visually inspect joint for proper seating and alignment.
Use the following procedure in order to tighten the clamps (4):
1. Tighten the bolts (5) to 25 6 N m (221 53 lb in).
2. Lightly tap around the clamps.
3. Again tighten the bolts (5) to 25 6 N m (221 53 lb in).
5 30 437-7470 Bolt
6 4 226-6575 Washer Before assembly, lubricate the washer faces with Loctite Nickel Anti Seize.
7 4 141-2456 Bolt Before assembly, lubricate the threads with Loctite Nickel Anti Seize.
8 4 5P-8245 Hard Washer Before assembly, lubricate the washer faces with Loctite Nickel Anti Seize.
9 4 6V-4605 Locknut Torque each bolt twice in criss-cross pattern.
10 12 303-9450 Bolt Before assembly, lubricate the threads with Loctite Nickel Anti Seize.
Torque to 240 40 N m (177 30 lb ft).
11 1 340-2663 Bellows As Allowable offset for the bellows assemblies from the center of the casting's inner diameter is 1.5 mm (0.06 inch).