CORE AS-ENGINE OIL COOLER 1352403 - Caterpillar

PID 0111 FMI 11Conditions Which Generate This Code:Note: This diagnostic code represents a critical event. This diagnostic code does not represent an electronic system fault.The Engine Control Module (ECM) detects the following conditions:
The signal voltage from the "2 Wire Float " sensor is between 2.5 V and 3.15 V.
The reading for the coolant level sensor has been low for more than ten seconds.
The ignition key switch is in the ON position or the engine has been running for more than 30 seconds.
"Coolant Level Sensor" must be programmed to "4-Pin", "2-Pin Switch", or "2-Wire Float Sensor".System Response:If "Engine Monitoring" is programmed to "", the check engine lamp will flash and the warning lamp will illuminate continuously.If "Engine Monitoring" is programmed to "DERATE" or "SHUTDOWN", the check engine lamp and the warning lamp will flash.This diagnostic code requires a customer password in order to be cleared."DIAG" will be displayed next to "Engine Coolant Level" on the status screen.Possible Performance Effect:If "Engine Monitoring" is programmed to "DERATE" or "SHUTDOWN", the vehicle speed is limited to a maximum of 72 km/h (45 mph), and the power is limited. The engine will shut down if conditions exist for a long enough period in the SHUTDOWN mode.Troubleshooting:"2-Pin Switch"GMT-560 applications can use a "2-pin switch" to monitor coolant level. To use a "2-pin switch", the parameter "Manufacturer/Model" must be programmed to "GMT-560" and the parameter "Coolant Level Sensor" must be programmed to "2-pin switch". The diagnostic fault codes for the coolant level sensors are disabled when the "Coolant Level Sensor" parameter is programmed to "2-pin switch". The switch is connected to P1/J1:49 ( coolant level switch) and to P1/J1:5 (AP sensor/switch sensor common). If the coolant level is normal, the switch should be closed and P1/J1:49 connected to ground. The warning lamp will be illuminated via the J1939 data link when the coolant is low. Test Step 1. Check the Level of the CoolantVisually check the level of the coolant. Ensure that the coolant level switch is fully immersed in the coolant.Expected Result:The coolant is at the proper level.Results:
OK - Proceed to Test Step 2.
Not OK - Repair: Fill the cooling system with the proper coolant to the correct level. For further information, refer to the Operations and Maintenance Manual.STOPTest Step 2. Inspect Electrical Connectors and Wiring
Thoroughly inspect the following connectors:
J1/P1 ECM vehicle harness connector
Harness for the connector to the coolant level switch
Connector terminals for the switchRefer to Troubleshooting, "Electrical Connectors - Inspect" for details.
Perform a 45 N (10 lb) pull test on each of the wires in the ECM connector that are associated with the appropriate diagnostic code.
Check the ECM connector (allen head screw) for the proper torque. Refer to Troubleshooting, "Electrical Connectors - Inspect" for details.
Check the harness and wiring for abrasion and pinch points from the appropriate sensor back to the ECM. Expected Result:All connectors, pins and sockets are completely coupled and/or inserted and the harness and wiring are free of corrosion, of abrasion or of pinch points.Results:
OK - Proceed to