CORE AS 1790725 - Caterpillar

Illustration 1 g01804453
Schematic of the "Solenoid Valve (Travel Speed)"
This diagnostic code is associated with the "Solenoid Valve (Travel Speed)". The FMI 03 means that the ECM has determined that the voltage of the solenoid circuit is above normal. The possible causes of the diagnostic code are listed below:
The energize circuit of the solenoid is shorted to the +battery circuit.
The ECM has failed. This is unlikely.Note: The Machine ECM is equipped with LED indicators that serve as a self-diagnostic check. With the key start switch ON, the following can be determined by the ECM indicator lights: If all of the LED lights are Off, voltage is not being supplied to the Machine ECM. Check for power to the ECM. If the yellow LED is Flashing, a communication error exists on the "CAN" data-link circuit. If the yellow LED is constantly On, the Machine ECM software may be missing / not loaded. If the red LED is Flashing, the Machine ECM has failed and may need replacement. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0598 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO THE +BATTERY CIRCUIT.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connectors from the solenoid and the ECM.
At the machine harness connector for the ECM, measure the resistance from contact J2-3 (wire 763-BU(Blue)) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-3 (763-BU(Blue)) and the circuit that has a low resistance measurement. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE OPERATION OF THE ECMThe disconnect switch and the key start switch remain in the OFF position. The machine harness connectors for the solenoid and the ECM remain disconnected.
At the harness connector for the Machine ECM J2, use a 151-6320 Removal Tool to remove the wire for the signal of the solenoid 763-BU(Blue) and the socket at contact J2-3 from the harness connector.
Reconnect the machine harness J1 and J2 connectors to the ECM.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the active CID 0598 FMI 03 diagnostic code. Expected Result:The CID 0598 FMI 03 diagnostic code is no longer active.