CORE AS-HYDRAULIC OIL COOLER 1808690 - Caterpillar

Installation of 2U-6795 Plugs
Illustration 1 g01316921
Typical example of sensor location for the D40D, D400D and D400 (1) Cover (2) Jam Nut (3) Sensor (4) 2U-6795 Plugs (5) Input Gear
Loosen jam nut (2) and remove the sensor (3) .
Remove the shim pack together with cover (1) .
Clean all traces of oil from the face of input gear (5). Be sure to thoroughly clean holes (A) .
Apply 6V-1541 Quick Cure Primer and 9S-3265 Compound on 2U-6795 Plugs (4). Install the plugs in holes (A) .
Install cover (1) and the shim pack.
Reinstall sensor (3). Refer to "Adjusting and Installing the Sensor".Adjusting and Installing the Sensor
Illustration 2 g01317310
Typical example of sensor location for the D40D, D400D and D400 (1) Cover (2) Jam Nut (3) Sensor (4) Plug
Illustration 3 g01317009
Typical example of sensor location for the D350E and D400E (1) Cover (2) Jam Nut (3) Sensor (4) Plug
Block the trailer wheel.
Raise one tractor wheel off the ground and block the frame.
Turn the wheel until one of plugs (4) is opposite the hole for the sensor in cover (1) .
Carefully install sensor (3) into the hole in cover (1) until the sensor contacts plug (4). Wind the sensor one turn away from the plug and tighten jam nut (2) .