CORE AS-RADIATOR 1844830 - Caterpillar

Brace The Lift Cylinder (7)
Illustration 8 g01407376
This safety message is located on the brace for the loader lift arm.
When performing any work underneath a raised loader lift arm, the loader lift arm brace must be in place. Install the loader lift arm brace as follows.
Empty loader bucket. Remove pin that secures loader lift arm brace to left loader arm. Raise the loader arms with the bucket in the dump position.
Position service brace over left lift cylinder with flat end against cylinder end.
Push pin through holes of loader lift arm brace and install cotter pin.
Slowly lower loader arms until brace contacts the top of the lift cylinder and bosses on loader arm.
To remove loader lift arm brace, reverse procedure.Failure to follow this procedure can result in death or serious injury if the loader arms are accidentally lowered.
Refer to Operation and Maintenance Manual, "Lift Cylinder Brace - Connect and Disconnect" for more information.Pressurized System (8)This safety message is located on the cooling system filler cap.
g01370913
Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure.
High Cylinder Pressure (9)This safety message is located on both sides of the boom near the connection with the stick.
g01407379
High Pressure Cylinder. Failure to read and follow these instructions can cause rapidly discharging gas and/or hydraulic fluid which can result in death, personal injury and property damage.
Seat Belt (10)
Illustration 9 g01370908
This safety message is located above the engine start switch.
A seat belt should be worn at all times during machine operation to prevent serious injury or death in the event of an accident or machine overturn. Failure to wear a seat belt during machine operation may result in serious injury or death.
High Pressure Accumulator (11)This safety message is located next to the accumulator if the machine is equipped with the option for ride control. The accumulator is located behind the battery box.
g01370912
Hydraulic accumulator contains gas and oil under high pressure. Improper removal or repair procedures could cause severe injury. To remove or repair, instructions in the service manual must be followed. Special equipment is required for testing and charging.
Product Link (12) (If Equipped)This safety message is located in the front of the cab on the left post.
g01381177
This machine is equipped with a Caterpillar Product Link communication device which must be deactivated within 12 m (40 ft) of a blast zone. Failure to do so could result in serious injury or death.