CORE AS-HYDRAULIC OIL COOLER 2042640 - Caterpillar

Hystat Transmission Features
Two Speed Control
The Two Speed Control shifts the motors between low speed and high speed. The two speed indicator will be illuminated while in high speed.Creep Control
Creep Control adjusts the maximum speed of the machine. Creep Control will not allow the motors to shift into high speed. The creep control indicator will be illuminated while in creep mode.Joystick Steering and Speed Control
The joystick steering and speed control is used to determine the left and right track command.The steering and speed commands will be determined based on the joystick pattern configuration. Pattern "1 " (Cat) joystick mapping uses the left joystick y-axis to determine the speed command and the left joystick x-axis for the steer command. Pattern "2" (alternate) joystick mapping uses the left joystick y-axis to determine the left track command and the right joystick y-axis to determine the right track command. Creep Control, certain Failure Modes, and the desired operation all determine the magnitude of the commands.Neutral Interlock
The neutral interlock feature prevents the machine from moving until all interlock conditions are satisfied. The neutral interlock feature will bring the machine to stop if certain faults are detected, certain conditions are not maintained during operation, or the parking brake is applied.Underspeed Control
The underspeed control feature prevents the engine from lugging below a determined speed during high load applications in order to optimize machine performance and prevent engine stall.Fault Management Control
The fault management control feature is used to monitor fault signals in the Hystat system and activate the appropriate fault mode.Unexpected Motor Speed Detection
The unexpected motor speed detection feature safely disables the hystat system during unexpected motor speed conditions.Closed Loop Control
The closed loop control provides straight tracking, predictable steering,and unexpected motion control.Implement Control System Features
Auxiliary Bleed Off Control
Allows the ECM to energize auxiliary solenoids with the key on and the engine off to bleed any residual auxiliary circuit pressure to tank. This feature is for the primary auxiliary circuit only.Auxiliary Tool Control
The purpose of this feature is to provide the operator a means to control the hydraulic oil flow to a tool attached to the front of the skid steer loader. Examples of commonly used tools are multi-purpose buckets, large brooms, grapple buckets, cold planers, etc.Bucket Tilt Control
Allows the ECM to control the rackback and dump movement of the loader bucket based on operator input through the x-axis movement of the right control joystick.Lift Arm Raise/Lower Control
Allows the ECM to control the up and down movement of the loader lift arms based on operator input through the implement control joysticks.Continuous Flow Control
The purpose of this feature is to provide the operator a means to continuously operate the auxiliary hydraulic circuit without having to actuate the proportional or on/off input. This feature will be used with tools such as a broom or an auger.Interlock Override Control
The interlock override feature is used in conjunction with the continuous flow function so the operator can set hydraulic flow to the work tool and then exit the machine to enable the use