CORE AS-CONDENSER 2197496 - Caterpillar

Introduction
CapSure sidebar protectors are available that can be used in place of the current standard drive-in pin and retainer systems.Do not perform any procedure in this publication or order any parts until you understand the information that is contained in this publication.Required Parts
Table 1
Required Parts
Model Standard Protector CapSure Protector As CapSure Pin Kit(1)
988 9J-9600 329-5954(2) 329-5953
990 1U-0740 329-5946(2) 329-5949
992 1U-0740 329-5946(2) 329-5949
993 1U-0740 329-5946(2) 329-5949
994 125-0800 304-5853 RH 304-5849
304-5854 LH
(1) Two per Protector
(2) Protectors are reversibleMounting Instructions
Illustration 1 g03705577
988 Pin Kit
Illustration 2 g03705579
990-994 Pin Kit
The CapSure protectors must be mounted with the retainer lock located toward the outside of the sidebar. The pin kits consist of a pin and two washers Refer to Illustrations 1 and 2.
Illustration 3 g03705587
Lock in open position
Illustration 4 g03705588
Thin Spacer
The thicker washer fits into the sidebar counterbore. The thinner ( 3 mm (0.12 inch)) washer is positioned on the inside or flat side of the sidebar if clearance between the protector and the sidebarallow. Install the thick washer into the sidebar counterbore, slide the protector on to the sidebar (Illustration 3) and attempt to insert the thin washer into place (Illustration 4). Discard the washer if the washer cannot fit in the gap.
Illustration 5 g03705599
990-994
Illustration 6 g03705600
988
Remove the sidebar protector. Place the thick washers in the counterbores. Insert the two pins through the sidebar. Slip the thin washers, if possible, over the ends of the pins away from the counterbore side. Slide the protector over the pins (990-994 Illustration 5). The 988 pins have a head at one end that fit in the lock cavity (Illustration 6).
Illustration 7 g03705802
Use a ½ inch wrench to rotate the locks clockwise with until the tangs hit the stop. Refer to Illustration 7.