CORE AS-RADIATOR 2540010 - Caterpillar

Removal Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A (1)     5P-7306     Housing     1    
5P-7305 Engine Turning Tool     1    
B     1U-7262     Telescoping Magnet     1    
( 1 ) This Tool is used in the aperture for the electric starting motor.Start By:
Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g02008013
If the crankshaft is installed, use Tooling (A) to rotate the crankshaft in order to gain access to the appropriate lifters .
Use Tooling (B) in order to remove lifters (1) .Note: Place a temporary identification mark on each lifter in order to identify the correct location.
Repeat Step 1 through Step 2 in order to remove the remaining lifters.Installation Procedure
Table 3
Required Tools    
Tool     Part Number     Part Description     Qty    
A (1)     5P-7306     Housing     1    
5P-7305 Engine Turning Tool     1    
B     1U-7262     Telescoping Magnet     1    
( 1 ) This Tool is used in the aperture for the electric starting motor.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Replace all lifters when a new camshaft is installed.
Clean the lifters. Follow Step 1.a through Step 1.c in order to inspect the lifters. Replace any worn lifters or damaged lifters.
Inspect the seat of the pushrod in the lifter for visual wear and damage.
Inspect the shank of the lifter for wear and damage.
Inspect the face of the lifter that runs on the camshaft for visual wear and damage.
If the crankshaft is installed, use Tooling (A) to rotate the crankshaft in order to allow access for the installation of appropriate lifters (1) .
Illustration 3 g02008013
Lubricate lifters (1) with clean engine oil.
Use Tooling (B) to install lifters (1) to the cylinder block. Ensure that used lifters are installed in the correct location.Note: The lifters should be free to rotate.
Repeat Step 1 through Step 4 in order to install the remaining lifters.End By: Install the camshaft. Refer to Disassembly and Assembly, "Camshaft" for the correct procedure.