CORE-RADIATOR 2724932 - Caterpillar

(Delco-Remy)
1. Spring. 2. Stop (adjust by bending stop). 3. Points.Generator Output Adjustments
(Paris-Rhone)
1. Spring. 2. Stop (adjust by bending stop). 3. Points.Delco-Remy Alternator; Pulley Nut Tightening
Tighten nut holding the pulley to a torque of 75 5 lb. ft. (100 7 N m) with the tools shown.
ALTERNATOR PULLEY INSTALLATION
1. 8S1588 Adapter (1/2" female to 3/8" male). 2. 8S1590 Socket (5/16" with 3/8" drive). 3. 1P2977 Tool Group. 8H8555 Socket (15/16" with 1/2" drive) not shown.Starting System
5P300 Electrical Tester Make reference to Special Instruction Form No. SEHS7006 and to the instructions inside the cover of the tester, when testing with the 5P300 Electrical Tester.Use a D.C. Voltmeter to find the starting system components which do not function.Put the DISCONNECT SWITCH in the ON position.Move the starting control switch to activate the starter solenoid. Starter solenoid operation can be heard as the pinion of the starter motor is engaged with the ring gear on the engine flywheel.If the solenoid for the starter motor will not operate, it is possible that the current from the battery is not getting to the solenoid. Fasten one lead of the voltmeter to the connection (terminal) for the battery cable on the solenoid. Put the other lead to a good ground. No voltmeter reading shows there is a broken circuit from the battery. More testing is necessary when there is a reading on the voltmeter.The solenoid operation also closes the electric circuit to the motor. Connect one lead of the voltmeter to the solenoid connection (terminal) that is fastened to the motor. Put the other lead to a good ground. Activate the starter solenoid and look at the voltmeter. A reading of battery voltage shows the problem is in the motor. The motor must be removed for further testing. No reading on the voltmeter shows that the solenoid contacts do not close. This is an indication of the need for repair to the solenoid or an adjustment to be made to the starter pinion clearance.Make a test by fastening one voltmeter lead to the connection (terminal) for the small wire at the solenoid and the other lead to the ground. Look at the voltmeter and activate the starter solenoid. A voltmeter reading shows that the problem is in the solenoid. No voltmeter reading shows that the problem is in the heat-start switch or wiring.Fasten one voltmeter lead to the heat-start switch at the connection (terminal) for the wire from the battery. Fasten the other lead to a good ground. No voltmeter reading indicates a broken circuit from the battery. Make a check of the circuit breaker and wiring. If there is voltmeter reading, the malfunction is in the heat-start switch or in the wiring.Fasten one lead of the voltmeter to the battery wire connection of the starter switch and put the other lead to a good ground. A voltmeter reading indicates a failure in the switch.A starter motor that operates too slow can have an overload because of too much friction in the engine being