CORE AS-OIL COOLER 3057606 - Caterpillar

The Cat ID will go through a sequence of screens when first powered up. Each of these screens is intended to provide set-up information to the driver before driving the vehicle. Cat ID will proceed through each screen, after displaying the screen for 3 seconds.It is recommended the power-up sequence be completed with all desired set-up information entered, and a desired information screen selected before driving the vehicle. An Active Diagnostic Code indicating a potentially seriouis engine problem will be automatically displayed by Cat ID and override the normal power-up sequence.
Depending on truck configuration, the engine may shut down when a potentially serious engine problem diagnostic code becomes active. The operator will be provided a warning indication 20 seconds before engine shutdown.
To avoid a hazardous condition that may cause injury or death, steer the vehicle to a suitable location to stop immediately when the warning code appears.
A complete map of the screens follows in the Cat ID Screen Map section.Display Screen Sequence
Theft Deterrent
The second screen shown, following power-up, is the THEFT DETERRENT title screen. The Cat ID will indicate the current status of the THEFT DETERRENT System, enabled, auto-enabled, or disabled. If the system is enabled, a password must be entered to start the engine. Press any key to continue.Driver Entry (3176B, C-10, C-12, 3406E, C-15, and C-16 Engines Only)
If programmed, the Cat ID will indicate the last driver stored as the active driver in the system. If the Fleet Trip Segment has been reset, the display will indicate NO ACTIVE DRIVER. Press any key to continue.State Crossing (3176B, C-10, C-12, 3406E, C-15, and C-16 Engines Only)
If programmed, this screen is the STATE CROSSING title screen. This indicates the last state stored as the current state in the system. If the Fleet Trip Segment has been reset, the display will indicate NO ACTIVE STATE. Press any key to continue.PM1 Maintenance
The final screen is a PM1 MAINTENANCE screen. This indicates when PM1 (oil and filter change) maintenance is due within 3000 miles/60 hours, or past due.Following the power-up sequence, the Cat ID will display the Miles Per Gallon screen under the INSTANTANEOUS DATA title screen. The driver can then go to the appropriate screen to enter the theft deterrent password, driver identification, and or state as necessary. The driver should then select the desired screen for viewing while driving, before starting the trip.
Whenever possible, the desired display selection should be made prior to operating the vehicle. Do not manipulate the display while the vehicle is moving. This could divert attention from driving efforts and result in personal injury or equipment damage.