CORE AS-RADIATOR 3355459 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
B     1P-1835     Adapter     1    
4C-9634 Puller Stud     1    
6V-3170 Double Acting Cylinder     1    
9U-6600 Hand Hydraulic Pump     1    
9U-6832 Nut     1    
4K-0684 Hard Washer     1    
C     1P-0510     Driver Gp     1    
Illustration 1 g00935851
Use Tooling (B) in order to install bearings (15) .Note: Install bearings (15) 5.6 .4 mm (.221 .016 inch) below the inside surfaces of axle assembly (15A) .
Use Tooling (C) (not shown) in order to install seals (14) .
Illustration 2 g00935859
Attach a suitable lifting device to arm assembly (12). The weight of arm assembly (12) is approximately 50 kg (110 lb). Install arm assembly (12) on cylinder (11) and rotate the bottom of arm assembly (12) downward. Install pin (13) .
Illustration 3 g00935860
Install washer (6) and bolt (5). Install washers (10) and bolts (9). Install lock (8) and bolt (7). Tighten bolt (7) to 698 27 N m (515 20 lb ft).Note: The dimension between the rod end of the wheel lean cylinder and washer (6) must be 0.76 mm (0.030 inch).
Illustration 4 g00935861
Attach a suitable lifting device to bar assembly (1). The weight of bar assembly (1) is approximately 80 kg (176 lb). Position bar assembly (1) on the machine. Lower bar assembly (1 ) on front frame assembly (4) .
Illustration 5 g00935862
Install a second lifting sling on bar assembly (1) and install bar assembly (1) in the original location on the machine. Install washers (2) and bolts (3) .End By: Install the wheel spindle and the wheel spindle housing. Refer to Disassembly and Assembly, "Wheel Spindle and Wheel Spindle Housing - Install".