AVSPARE.COM
parts catalog

CORE AS-RADIATOR 3983232 - Caterpillar


3983232 CORE AS-RADIATOR Caterpillar parts
Rating:
29
Alternative (cross code) number:
CA3983232
398-3232
3983232
Caterpillar 3983232 CORE AS-RADIATOR
Weight: 90 pounds 41 kg.

Buy CORE AS-RADIATOR 3983232 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 3
  For full view, you need register

Information:


Illustration 1 g00840269
Schematic of the Solenoid Valve (Axle Oil)This diagnostic code is associated with the Solenoid Valve (Axle Oil). The FMI 06 means that the ECM has determined that the current of the solenoid is above normal. The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1400 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The function for the tilt right will be disabled. The tilt lever must be recentered after the diagnostic code is corrected in order to allow the tilt function to operate.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness. Expected Result:CID 1400 FMI 06 changes to CID 1400 FMI 05 when the solenoid is disconnected.Results:
YES - CID 1400 FMI 06 changes to CID 1400 FMI 05 when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Stop.
NO - CID 1400 FMI 06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUND.
Turn the key start switch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connector(s) from the ECM.
At the machine harness connector, measure the resistance from the signal contact J2-7 (wire G725-GN) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-7 (wire G725-GN) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness. Stop.Test Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 1400 FMI 06. Expected Result:The CID 1400 FMI 06 is active. Results:
YES - The CID 1400 FMI 06 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM.

Caterpillar parts catalog:

Caterpillar parts catalog
950L Wheel Loader LXX00001-UP (MACHINE) POWERED BY C7.1 Engine
966L Wheel Loader FRS00001-UP (MACHINE) POWERED BY C9 Engine
972L Wheel Loader RFB00001-UP (MACHINE) POWERED BY C9.3 Engine
972M Wheel Loader L8E00001-UP (MACHINE) POWERED BY C9.3 Engine
966M Wheel Loader R8D00001-UP (MACHINE) POWERED BY C9.3 Engine
972M Wheel Loader M8W00001-UP (MACHINE) POWERED BY C9.3 Engine
966M Wheel Loader L8R00001-UP (MACHINE) POWERED BY C9.3 Engine
966L Wheel Loader FSL00001-UP (MACHINE) POWERED BY C9.3 Engine
972L Wheel Loader YJW00001-UP (MACHINE) POWERED BY C9.3 Engine


Parts core Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.