CORE AS-OIL COOLER 4227007 - Caterpillar

Illustration 4 g00652564
Connect fitting of tube assembly (34) to the ether starting aid.
Illustration 5 g00652547
Position two flanges (32) and hose assemblies (31) to the transmission oil cooler.
Install eight bolts (33) and the washers to flanges (32) in order to secure the hose assemblies (31) to the transmission oil cooler.
Illustration 6 g00652510
Install heater hoses (25) and (29) to the fittings. Tighten the clamps.
Position tube assembly (30) to the original location.
Install bolt (28) and the clip to the engine block in order to secure the tube assembly (30) to the engine.
Tighten clamp (26) and plug (27) .
Illustration 7 g00652493
Connect three hose assemblies (23) to air compressor (22) .
Install hose assemblies (23) into clips (24) .
Illustration 8 g00652484
Install implement pump drive shaft (21) between the engine and the implement pump.
Install eight bolts (20) to implement pump drive shaft (21). Tighten bolts (20) to a torque of 75 10 N m (55 7 lb ft).
Illustration 9 g00652479
Install guard (19) to the pump drive shaft assembly.
Install six bolts (18) in order to secure the guard to the mounting and secure the two halves together. The four bolts that hold the guard (19) to the mounting must be tightened to a torque of 135 20 N m (100 15 lb ft).
Illustration 10 g00652442
Position governor control housing (16) and cable (17) to the side of the engine.
Install six bolts (15) in order to secure governor control housing (16) to the side of the engine.
Illustration 11 g00652421
Connect two wire connectors (14) to the side of the engine.
Illustration 12 g00653089
Connect three wire connectors (9) .
Install three wire connectors (9) to the mounting brackets.
Connect two refrigerant hose assemblies (10) to refrigerant compressor (11) .
Illustration 13 g00653094
Connect cable (13) to supplemental steering relay (12) .
Illustration 14 g00652373
Connect cable (8) to electric starting motor (7) .
Install bolt (5) and the clip to the mounting.
Connect two wire terminals (4) to starter solenoid (6) .
Illustration 15 g00649656
Position dash assembly (3) to the mounting brackets.
Install two bolts (2) and the washers to dash assembly (3). One of the bolts is located on the right side of the machine. The remaining bolt is located on the left side of the machine.
Connect two wire connectors (1) to the mounting bracket.
Install the engine side covers.
Fill the refrigerant system with refrigerant to the correct pressure level. Refer to Service Manual, SENR5664, "Refrigerant and Heating Systems with R-134a Refrigerant" for the proper filling procedure.End By:
Install the fuel tank. Refer to Disassembly and Assembly, "Fual Tank - Install" for the correct procedure.
Install the hood. Refer to Disassembly and Assembly, "Hood - Install" for the correct procedure.
Install the battery box. Refer to Disassembly and Assembly, "Battery Box - Remove and Install" for the correct procedure.
Install the battery. Refer to Disassembly and Assembly, "Battery - Remove and Install" for the correct procedure.