CORE AS-AFTERCOOLER 5001462 - Caterpillar

Illustration 8 g01441733
Illustration 9 g01442152
Align front drive shaft (1) with the center of the bore. Use Tooling (A) (not shown) and the suitable lifting device in order to adjust the height of front drive shaft (1).
Illustration 10 g01441753
Illustration 11 g01441405
Use two people in order to install carrier bearing housing (8) so that the grease fitting is at the top. Install the washers, bolts (7), and nuts (9). The weight of carrier bearing housing (8) is approximately 32 kg (70 lb).
Illustration 12 g01441815
Illustration 13 g01441827
Raise the temperature of bearing cones (16). Install bearing cones (16) to front drive shaft (1). Apply a thin coat of oil to bearing cones (16).
Illustration 14 g01441891
Lower the temperature of the second bearing cup (15). Install bearing cup (15).
Illustration 15 g01441893
Install spacer (12).
Illustration 16 g01442062
Install O-ring seal (13).
Illustration 17 g01442098
Illustration 18 g00353805
Use Tooling (D) in order to install lip seal (14). Install lip seal (14) until lip seal (14) contacts the counterbore of bearing retainer (11). Make sure that the sealing lip of lip seal (14) is facing toward the outside of bearing retainer (11).
Lubricate the sealing lip of lip seal (14) with Tooling (E).
Illustration 19 g01441808
Install bearing retainer (11). Install the washers and bolts (10).
When the front drive shaft is installed, it must be installed in phase with the front axle assembly yoke. The front drive shaft must be installed in phase with the center and rear drive shafts. Serious component damage could occur. Be certain that all the joint groups, all the yokes, and all the lubricating fittings are aligned.
Illustration 20 g01442107
Install yoke (5) in correct rotation with the yoke of the front axle assembly.
Install O-ring seal (6) in the center of yoke (5).
Illustration 21 g01441388
Install the retainer and bolt (4) in order to fasten yoke (5) to the front drive shaft. Tighten bolt (4) to a torque of 530 70 N m (395 52 lb ft).
Remove Tooling (A).
Lubricate the front drive shaft and the carrier bearing. For the correct procedure, refer to the Operation and Maintenance Manual for your machine. End By:
Install the center drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Center) - Remove and Install".
Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".