CORE AS-OIL COOLER 7E5467 - Caterpillar

Personal injury or death can result if two persons are not used in the following procedure.
Specifications
Table 1
Stop Lamp Limit Switch Adjustment Specifications
Date Product or Component SN
Component Desired Value Actual Value
Brake Lamps "ON" using the 3.5 mm (0.14 inch) feeler gauge
Brake Lamps "OFF" using the 1.5 mm (0.06 inch) feeler gauge
Illustration 1 g03404771
(1) Plug
(2) Adjustment screw
Table 2
Torque specifications
Callout Torque
Plug (1) 1.4 0.3 N m (12.0 3.0 lb in) Introduction
The following procedure describes the setup, checking, and adjusting of the stop lamp limit switch.Test Preparation
Move the machine to a hard, level surface. The surface must also be dry and free of debris.
Engage the parking brake
Turn the ignition switch to the "OFF" position.
Ensure that there is no interference with other components when both brake pedals are applied and released. When both brake pedals are in the released position, the stop lamps for the machine should be in the "OFF" position. Test Procedure
Illustration 2 g03404772
Side view of the right service brake pedal
(3) Pedal stop
(4) Treadle heel stop
Insert a 3.5 mm (0.14 inch) feeler gauge between Treadle heel stop (4) and pedal stop (3) of both the left brake pedal and the right brake pedal. Monitor the stop lights. When the feeler gauges are in place, the stop lights should be ON. Remove the feeler gauges.
Insert a 1.5 mm (0.06 inch) feeler gauge between Treadle heel stop (4) and pedal stop (3) of both the left brake pedal and the right brake pedal. Monitor the stop light. When the feeler gauges are in place, the stop lights should be OFF. Remove the feeler gauges.
Ensure that the stop lights go ON and OFF when the brake pedals are applied and released. If the stop lights work properly, no adjustments are necessary at this time.
If steps 1, 2, and 3 are not satisfied, perform the following procedure. Adjustment Procedure
Insert a 3.5 mm (0.14 inch) feeler gauge between Treadle heel stop (4) and pedal stop (3) of both the left brake pedal and the right brake pedal.
Illustration 3 g03404773
(1) Plug
(2) Adjustment screw
Remove plug (1) and turn the adjustment screw for switch (2) counterclockwise in order to turn the stop lights OFF. Then, turn the adjustment screw for the switch clockwise until the stop lights turn ON. When the feeler gauges are in place, the stop lights should be ON. Remove the feeler gauges. The stop light should be OFF.
Insert the 1.5 mm (0.06 inch) feeler gauge between Treadle heel stop (4) and pedal stop (3) of both the left brake pedal and the right brake pedal. Monitor the stop lights. When the feeler gauges are in place, the stop lights should be OFF. Remove the feeler gauges.
Ensure that the stop lights go ON and OFF when both of the brake pedals are applied and released. Repeat steps 1, 2, and 3 if the stop lights do not work properly. Note: If the stop lights will not operate properly after the adjustment procedure, the limit switch will need to be replaced.
Install plug (1) and torque the plug