CORE ASSEM. 7N0125 - Caterpillar

There may be several specific safety messages on your generator set. The exact location and a description of the safety messages are reviewed in this section. Become familiar with all safety messages.Ensure that all of the safety messages are legible. Clean the safety messages or replace the safety messages if the words cannot be read or if the illustrations are not visible. Use a cloth, water, and soap to clean the safety messages. Do not use solvents, gasoline, or other harsh chemicals. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety messages. The safety messages that are loosened could drop off the engine.Replace any safety message that is damaged or missing. If a safety message is attached to a part of the engine that is replaced, install a new safety message on the replacement part. Your Caterpillar dealer can provide new safety messages.
Illustration 1 g03874610
Left side of enclosure
Illustration 2 g03874622
Right side of enclosure
Illustration 3 g03894627
Rear of enclosure
Illustration 4 g03896719
Illustration 5 g03897180
Illustration 6 g03897201
Illustration 7 g03897219Universal Warning (1)This safety message is located on the sides of the enclosure, on the control panel, near the breaker box, and on the terminal box.
Illustration 8 g01370904
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in serious injury or death.
Automatic Starting (2)This safety message is located on the sides of the enclosure, the breaker box, and the control panel.
Illustration 9 g01392484
When the engine is in the AUTOMATIC mode, the engine can start at any moment. To avoid personal injury, always remain clear of the the engine when the engine is in the AUTOMATIC mode.
Crush (3)This safety message is located on the sides of the enclosure.
Illustration 10 g01381178
Crushing hazard! Read and understand the instructions and warnings in the Operation and Maintenance manual. Failure to follow the instructions or heed the warnings could cause serious injury or death.
Electrocution (4)
This safety message is located on the sides of the terminal box, near the bus bars, on the control panel, and on the rear of the open generator set.
Illustration 11 g03430411
DANGER: Shock/Electrocution Hazard-Do not operate this equipment or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings will result in serious injury or death.
Do not connect generator to a utility electrical distribution system unless it is isolated from the system. Electrical feedback into the distribution system can occur and could cause personal injury or death.Open and secure main distribution system switch, or if the connection is permanent, install a double throw transfer switch to prevent electrical feedback. Some generators are specifically approved by a utility to run in parallel with the distribution system and isolation may not be required. Always check with your utility as to the applicable circumstances.
Hot Surface (5)This safety message is located on the sides of the generator, on the front and rear of the