CORE AS-RADIATOR 7N4384 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments, the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption, service hours, mileage and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Coolant Sample (Level 1) - Obtain
Coolant Sample (Level 2) - Obtain
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Oil Level Gauge - Calibrate
Fuel System - Prime
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Water Separator - Check/Drain
Walk-Around Inspection
PM Level 1 - Every 24 000 km (15 000 miles) or 5700 L (1500 US gal) of Fuel or 400 Service Hours or 6 Months
Hoses and Clamps - Inspect/Replace
Every 32 000 km (20 000 miles) or 9464 L (2500 US gal) of Fuel or 300 Service Hours
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
PM Level 1 - Every 48 000 km (30 000 miles) or 15 520 L (4100 US gal) of Fuel or 500 Service Hours
Air Compressor Filter - Clean/Replace
Air Shutoff - Test
Alternator - Inspect
Battery Electrolyte Level - Check
Belt Tensioner - Check
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Crankcase Breather - Clean
Fuel System Primary Filter - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Grounding Stud - Inspect/Clean/Tighten
Hoses and Clamps - Inspect/Replace
Between 24 000 and 96 000 km (15 000 and 60 000 miles)
Engine Valve Lash - Check
Fuel Injector - Check
Valve Actuators - Check
Between 24 000 and 96 000 km (15 000 and 60 000 miles) (Between the First and Fourth Oil Change)
Fuel Injector - Check
PM Level 2 - Every 320 000 km (200 000 miles) or 125 000 L (33 000 US gal) of Fuel or 4000 Service Hours or 2 Years
Aftercooler Core - Clean/Test
Coolant Temperature Regulator - Replace
Fan Drive Bearing - Lubricate
Radiator - Clean
PM Level 3 - Every 483 000 km (300 000 miles) or 190 000 L (50 000 US gal) of Fuel or 6000 Service Hours or 3 Years
Air Compressor - Check
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Valve Lash - Check
Fuel Injector - Check
Turbocharger - Inspect
Valve Actuators - Check