CORNER AS 2452797 - Caterpillar

Illustration 7 g00347987
The warning sign is located at the rear of the cab below the rear window.
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
Drawbar
Illustration 8 g00488120
The warning sign is located below the shield for the power take-off.
Failure to follow these instructions can result in serious operator or bystander injury.
Pull only from drawbar. Pulling from any other point can cause rear overturn.
Stop PTO and engine before servicing tractor or changing implements.
Do not operate with unshielded PTO.
Use safety chains to tow equipment.
Position drawbar at 410 mm from end of 1000 RPM PTO shaft with Ø 35 mm and 510 mm with Ø 45.5 mm to drawbar hole.
Three-Point Hitch Control
Illustration 9 g00512236
The warning sign is located on both rear fenders.
To avoid injury do not stand on or between implement and machine while operating lift control.
Transmission
Illustration 10 g00347983
The warning sign is located on the right side console in front of the transmission control lever.
Always engage parking brake before dismounting. Transmission will not prevent machine from rolling when engine is shut off.
Accumulator
Illustration 11 g00512238
The warning sign is located on the accumulator on the undercarriage.
Pressurized Vessel
Use dry nitrogen gas only
Special equipment required for testing and charging
See service instructions for additional information
Precharge pressure 15168 kPa (2200 psi)
Engine Shutdown
Illustration 12 g00512241
The warning sign is located above the right side console.
If instrument panel flashes "STOP" and continuous alarm sounds, then within 30 seconds the engine automatically will shutdown unless corrective action is taken.Failure to stop or override the automatic shutdown system will cause loss of steering control and power-assist to brakes possibly resulting personal injury. Without engine power this tractor will not steer.Override automatic engine shutdown and drive to a safe location to stop by depressing the red top of the override switch to the right of the steering column. Only use the override switch to drive far enough to avoid a dangerous situation, such as traffic.Proceed to a safe stopping area, stop the engine, determine the cause of the shutdown alarm, and take corrective action.
Draft Control
Illustration 13 g00347980
The warning sign is located on the left side of the cab behind the door.
To avoid injury from unintentional hitch movement, always set the position/draft sensitivity knob to position 1, the full position control setting, (fully counterclockwise detent) when not using draft control, such as when working near the hitch and attached implements, or when transporting or roading equipment.