CORNER AS 7P8440 - Caterpillar

Yoke (11) is located on the opposite side. Remove bolt (9), retainer (10), and yoke (11). Remove O-ring seal (8) (not shown).
Illustration 4 g02386918
Attach Tooling (A) and a suitable lifting device to Locations (X). Remove the bolts for cover assembly (12). The weight of cover assembly (12) is approximately 59 kg (130 lb).
Use Tooling (D) to break the seal between the case assembly and cover assembly (12). The holes for inserting Tooling (D) are at Locations (X). Remove cover assembly (12) .
Illustration 5 g02389844
Remove the retainer and remove gear (13) .
Attach Tooling (B) and a suitable lifting device to shaft assembly (14). The weight of shaft assembly (14) is approximately 75 kg (165 lb). Remove shaft assembly (14) .
Illustration 6 g02390917
Mark the location of bearing cage (17) for assembly purposes. Remove bolts (16). Use Tooling (C) in order to remove bearing cage (17). Remove shims (15) (not shown).
Repeat Step 10 for the other bearing cages.
Illustration 7 g02391160
Remove bolt (19). Remove tube assembly (18) and the O-ring seals.
Illustration 8 g02393131
Attach Tooling (A) and a suitable lifting device to case (21). Remove bolts (20) and (22). The weight of case assembly (21) is approximately 365 kg (805 lb).
Use Tooling (D) to break the seal of case assembly (21). Remove case assembly (21) .
Illustration 9 g02387079
Use a suitable lifting device in order to reposition case assembly (21) onto suitable cribbing.
Illustration 10 g02393377
Remove bolts (23). Use Tooling (D) in order to remove pump drive cover (24) and pump drive gear (25) .
Illustration 11 g02393458
Remove O-ring seal (26) and gear (25) from cover (24) .
Illustration 12 g02393479
Use Tooling (E) in order to remove bearings (27) from gear (25) .
Illustration 13 g02393597
View from below.
Remove bolts (28), plate (29) and O-ring seal (30) .
Illustration 14 g02393627
Note: Care should be taken when bolt (31) is removed. When the bolt is removed, shaft (32) could fall out of the bore.
Remove bolt (31) and remove shaft (32) from the bore.
Illustration 15 g02394957
Remove idler gear (34) and remove thrust washers (33) .
Illustration 16 g02395140
Remove bearing (36) from idler gear (34) .