COUNTERWEIGHT AS 2993531 - Caterpillar

maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption, service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Recycle
Battery - Replace
Circuit Breakers - Reset
Coolant - Change
Coolant Extender (ELC) - Add
Enclosure - Inspect
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Air Cleaner Element (Single Element) - Inspect/Replace
Fuel System - Prime
Generator - Dry
Generator Set - Test
Generator Winding Insulation - Test
Daily
Belts - Inspect/Adjust/Replace
Control Panel - Inspect/Test
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Generator Load - Check
Walk-Around Inspection
Every Week
Automatic Start/Stop - Inspect
Space Heater - Test
Stator Winding Temperature - Test
Voltage and Frequency - Check
Every 250 Service Hours
Coolant Sample (Level 1) - Obtain
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours or 1 Year
Engine Air Cleaner Element (Single Element) - Inspect/Replace
Every 2000 Service Hours or 6 Months
Stator Lead - Check
Every Year
Coolant Sample (Level 2) - Obtain
Varistor - Check
Varistor - Inspect
Every 14 200 L (3750 US gal) of Fuel or 500 Service Hours
Battery Charger - Check
Every 6900 L (1820 US gal) of Fuel or 500 Service Hours or 1 Year
Auxiliary Water Pump (Rubber Impeller) - Inspect
Battery Electrolyte Level - Check
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Heat Exchanger - Inspect
Hoses and Clamps - Inspect/Replace
Sea Water Strainer - Clean/Inspect
Every 13 800 L (3650 US gal) of Fuel or 1000 Service Hours or 1 Year
Engine Valve Lash - Check
Every 27 600 L (7290 US gal) of Fuel or 2000 Service Hours or 2 Years
Aftercooler Core - Inspect/Clean/Test
Alternator - Inspect
Coolant Temperature Regulator - Replace
Generator - Inspect
Generator Set Vibration - Test/Record
Rotating Rectifier - Inspect/Test
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 110 400 L (29 160 US gal) of Fuel or 8000 Service Hours
Engine Crankcase Breather - Replace
Every 165 600 L (43 750 US gal) of Fuel or 12 000 Service Hours
Overhaul Considerations