COUNTERWEIGHT GP 3828291 - Caterpillar

Illustration 1 g02207696
VIMSTM analysis control circuitThis diagnostic code indicates the Chassis ECM detects parameters from the VIMSTM Analysis control module are not at the proper rate. The parameters update rate generated by theVIMSTM Analysis control module is not correct.This diagnostic code could be caused by:
Incorrect Chassis ECM software
Incorrect VIMS Analysis ECM software
Incompatible software
Incorrect Chassis ECM
Incorrect VIMS Analysis ECM
Failed ECMUse a calibrated digital multimeter for this procedure.Test Step 1. CHECK PART NUMBERS
Use Cat® Electronic Technician (Cat® ET) to verify that the installed part numbers are correct and compatible.Expected Result:The part numbers are correct.Results:
OK - The part numbers are correct. Proceed to Test Step 2.
NOT OK - The part numbers are not correct.Repair: Install the correct ECMs, see Testing and Adjusting, "Electronic Control Module (ECM) - Replace".Flash the correct software, see Testing and Adjusting, "Electronic Control Module (ECM) - Flash Program".STOPTest Step 2. CHECK FOR DIAGNOSTIC CODES
Check the status of CID 1089 FMI 14.Expected Result:CID 1089 FMI 14 is not active. Results:
OK - CID 1089 FMI 14 is not active. Repair: The initial diagnostic code was probably caused by a poor connection at one of the connectors that was checked. Clear the diagnostic code.STOP
NOT OK - CID 1089 FMI 14 is active. The ECM may have failed.Repair: Exit this procedure and perform this procedure again. Contact the technical communicator at your Cat® dealer. If the ECM requires replacement, see Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP