AVSPARE.COM
parts catalog

COUPLER-FEMALE 2809462 - Caterpillar



2809462 COUPLER-FEMALE Caterpillar parts COUPLER
Rating:
86
Alternative (cross code) number:
CA2809462
280-9462
2809462
Caterpillar 2809462 COUPLER-FEMALE

Buy COUPLER-FEMALE 2809462 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Pressure Lubrication Procedure
Some type of oil reservoir with a pressure gauge is needed to do the pressure lubrication. In the procedure that follows, a tank assembly from a 1P540 Flow Checking Tool Group is used as an example. If one of these tanks is used to do the pressure lubrication, the inside of the tank must be completely clean. Never use the same tank assembly for both pressure lubrication and for fuel flow checking. It is not possible to get the tank assembly clean enough to do both operations. Any amount of dirt, debris, etc., can cause fuel nozzle failure, when the tank is used for fuel flow checking. Other sources of clean oil under pressure, such as a service shop central oil supply, can also be used for pressure lubrication.
Air pressure must not be more than 50 psi (345 kPa) at any time.
(1) Adjust the air pressure regulator to 35 5 psi (240 35 kPa).(2) See the LUBRICATION AND MAINTENANCE GUIDE for the engine model that is to have the pressure lubrication, and find the amount of oil that is needed to fill the engine crankcase to the correct oil level. Put 30% of this amount of oil in the tank assembly for use in the pressure lubrication procedure. For some engines, 30% of the crankcase capacity will make it necessary to fill the tank assembly, shown here, more than one time. (3) For pressure lubrication of an engine, use the necessary fittings and hose to connect the tank assembly to a port that connects to the main oil gallery of the cylinder block. Illustrations (A), (B) and (C) above are examples of engine models. For engine models (A), remove a plug at the rear of the right side cylinder head and make the connection as shown. For engine models (B) and (C), remove a plug (1) or (2) on the right side of the cylinder block and connect the pressure lubrication equipment.(4) Connect shop air pressure to the tank assembly [tank assembly air pressure regulator must be adjusted to 35 5 psi (240 35 kPa)] to move the oil from the reservoir into the main oil gallery and engine lubrication passages. If shop air pressure is not available, the tank assembly shown has a hand pump that can be used to get the minimum pressure needed.(5) After the pressure lubrication procedure is complete, shut off the air pressure and disconnect the pressure lubrication equipment. Be sure to install the plug in the hole that was used for pressure lubrication.(6) Add the remainder of oil needed to fill the engine crankcase to its correct level. Remember that 30% of the oil needed to fill the crankcase has already been installed during the pressure lubrication procedure. Before the engine is started, turn the engine a few revolutions with the governor control in the FUEL OFF position, to get movement of the lubrication oil within the engine.


Parts coupler Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.