COUPLER-MALE 8T5373 - Caterpillar

Illustration 1 g00819857
Typical example
(1) Height of the camshaft lobe for the inlet and exhaust valves C0.5, C0.7, C1.1 and C1.6 ... 26.955 to 27.010 mm (1.0612 to 1.0634 inch)C1.5 and C2.2 ... 34.065 to 34.120 mm (1.3411 to 1.3433 inch)Service limit C0.5, C0.7, C1.1 and C1.6 ... 26.5 mm (1.0433 inch)C1.5 and C2.2 ... 33.7 mm (1.3270 inch) (2) Height of the camshaft lobe for the fuel injection pump C0.5, C0.7 and C1.1 ... 39.900 to 40.100 mm (1.5709 to 1.5787 inch)C1.5, C1.6 and C2.2 ... 41.940 to 42.060 mm (1.6512 to 1.6559 inch)Service limit C0.5, C0.7, C1.1 and C1.6 ... 39.8 mm (1.5669 inch)C1.5 and C2.2 ... 41.8 mm (1.6450 inch) (3) Height of the camshaft lobe for the fuel transfer pump C0.5, C0.7, C1.1 and C1.6 ... 27.900 to 28.000 mm (1.0984 to 1.1024 inch)C1.5 and C2.2 ... 31.900 to 32.000 mm (1.2559 to 1.2598 inch)Service limit C0.5, C0.7, C1.1 and C1.6 ... 27.0 mm (1.0630 inch)C1.5 and C2.2 ... 30.0 mm (1.1810 inch)
Illustration 2 g00295323 (A) Actual camshaft lobe lift (B) Height of the camshaft lobe (C) Base circle To determine the lobe lift, use the procedure that follows:
Measure the height of the camshaft lobe (B).
Measure the base circle (C).
Subtract the base circle that is found in Step 2 from the height of the camshaft lobe that is found in Step 1. The difference is the actual camshaft lobe lift.
Illustration 3 g01297670
Typical example
(4) Tighten the setscrews for the retainer plate for the camshaft to the following torque. ... 11 N m (8.0 lb ft) (5) Retainer plate for the camshaft (6) Camshaft gear