COUPLING 0962120 - Caterpillar

Illustration 6 g00790598
The above illustration is shown after the governor actuator has completed the calibration.Warnings
If the fourth line of the display shows any of the following warnings a failure is present. See the following table 2 for a detailed description of the warning displays.
Table 2
Warning Codes    
Display     Warning     Corrective Action    
Wire Pitch X (X is a number from 0 to 9)     Wire nut is installed too loose by X pitch. X can be a positive or negative number. Turn clockwise.     Tighten the accelerator cable by the displayed pitch. Perform the calibration again.    
Wire Pitch X (X is number from -9 to 0)     Wire nut is installed too tight by X pitch. X can be a positive or negative number. Turn clockwise.     Loosen the accelerator cable by the displayed pitch. Perform the calibration again.    
01     Insufficient high idle     High idle is less than the specified value due to malfunction of the engine, incorrect installation of the governor cable, poor fuel, etc. After the engine has been inspected for a malfunction, reinstall the cable and perform the calibration again.    
02     Incorrect installation of cable     Reinstall the cable and perform the calibration again.    
03     Excessive low idle     Low idle is more than the value specified due to a malfunction in the engine, an incorrectly installed governor cable, etc. After the engine has been inspected, reinstall the cable and perform the calibration again.    
04     Excessive hysteresis     Ensure that the cable is adjusted correctly. Reinstall the cable and perform the calibration again.    
05     Unstable high idle     High idle is unstable due to a malfunction in the engine, an incorrect installation of the governor cable, etc. After the engine has been inspected, reinstall the cable and perform the calibration again.    
06     Unstable dial speed     The speed for the dial setting is unstable due to a malfunction in the engine, an incorrectly installed cable, etc. After the engine has been inspected, reinstall the cable and perform the calibration again.    Errors
If the fourth line of the display shows any of the following errors a failure is present. See the following table for a detailed description of the error displays.
Table 3
Error Codes For The Governor Actuator    
Error Code     Description Of The Error     Corrective Action    
ERROR 01     Improper calibration of another device     Stop the calibration of the other device. Perform one calibration at a time.    
ERROR 02     Improper calibration of another module     Stop the calibration of the other device. Perform one calibration at a time.    
ERROR 03     Failure of the interlock signal     Perform the troubleshooting procedure that will confirm the signal that communicates with the monitor.    
ERROR 11     Abnormal speed sensor     Troubleshoot the confirmation of the speed sensor.    
ERROR 12     Engine stop     Perform the calibration again. Try to prevent