COUPLING 1034969 - Caterpillar

Logging In
Once the web interface of the drill interface module is accessed, to configure the device, a login is required.The "Log In" button is provided to access additional web pages. Once the "Log In" button is pressed, the page to enter a username and password displays.The following information must be used to log in:
For dealers:Username: Dealer
Password: Dealer
For customers:Username: Customer
Password: Customer
Note: The default user names cannot be changed. The user names correspond with the user access level. An invalid username and/or password will be rejected and the "Invalid username or password" error message will display.Once a valid username and password are accepted, the user is granted access to certain web-pages based on the access level defined for that user.Note: The "Log Out" button is displayed once a user is logged in.Device Configuration
Note: To access the "Configuration" menu, a user login is required.The initial configuration of the drill interface module is performed from the "Configuration" menu. This section provides the procedures to configure the following items in the "Configuration" menu:
"Device Identification"
"Ethernet Serial Bridge Configuration"
"TCP/IP Configuration"
"CANLink File Upload""Device Identification"
Illustration 8 g03352657
"Device Identification" screen
The device identification is the identifier for the specific drill. The identifier can be as long as 40 characters. Also, the identifier is used to identify the device in the web interface of the drill interface module.Perform the following procedure to configure the device identification:
Select "Device Identification" from the "Configuration" menu.
Enter the machine ID of the drill that has the drill interface module. Refer to Illustration 8.
Select "Apply".The message "Configuration Save and Activate." will appear."Ethernet Serial Bridge Configuration"
Illustration 9 g03352661
"Ethernet Serial Bridge Configuration" screen
The "Ethernet Serial Bridge Configuration" screen is provided to configure legacy serial devices."TCP/IP Configuration"
The settings for the "TCP/IP Configuration" set the network information for the drill interface module to be accessed over the Wireless Local Area Network (WLAN).This page will display the IP address that was entered using the Cat ET software. The "TCP/IP Configuration" page is provided to modify the IP address of the drill interface module."CANLink File Upload"
Illustration 10 g03352666
"CANLink File Upload" screen
The "CANLink File Upload" page is provided to upload a CAN link configuration file to the device.Note: A CAN link configuration file is required for DR540, DR560, and MD5150 articulated drills only.GPS Configuration
The "GPS" menu is provided to configure specific GPS settings. The following menus are accessed from the "GPS" menu to complete the GPS configuration:
"Corrections Configuration"
"APP File Upload""Corrections Configuration"
Illustration 11 g03352685
"Corrections Configuration" screen
The "GPS Corrections Configuration" page is provided to enter the UDP port value that is configured for the base station. This value is the port number that the drill interface module listens on for GPS corrections. Refer to Illustration 11.Perform the following procedure to configure the UDP Port settings:
Enter the port number in the "UDP Port" field. The value must be the same that is configured for the base station.Note: The default value for the "UDP Port" is 3784.
Press the "Apply" button.The "UDP Port Number Was Saved successfully" will display.
Once the drill interface module receives GPS corrections, the "Correction Type" field displays the