COUPLING GP-AUXILIARY DRIVE 1482711 - Caterpillar

Display Brightness
The brightness of the screen on the display should be adjusted in order to suit your working conditions. In order to adjust the brightness of the screen, use the following combination of keys:
To increase the display brightness, press and hold down the menu key (11) and then press the "+" key (7) .
To decrease the display brightness, hold down on the the menu key (11) and press the "-" key (9) .Display Direction
The user can set the display so that it matches the design when viewed from the front or back window of the machine. In order to set the direction of the display, complete the following steps:
From the "Setup Menu - Configuration" dialog, press the arrow keys until "Display Direction" is highlighted.
Press the "OK" key.The "Display Direction" dialog will appear. Refer to Illustration 11.
Illustration 11 g01450719
Press the Arrow keys in order to select the following:Forward - for the front window viewBackwards - for the back window view
Press the "OK" key in order to confirm the setting. Press the escape key in order to close the dialog without saving the changes.
Press the escape key in order to return to the "Setup Menu - Configuration" dialog.GPS Accuracy Mode
As a default, the "GPS Accuracy Mode" is available for all configurations of the AccuGrade System. Some of the options, soft keys, or views that are discussed in this manual may not be accessible. The operator configuration settings can be used in order to turn on soft keys, views and options. Use the "GPS Accuracy Mode" dialog in order to set the maximum GPS error estimate that is acceptable for your application.Refer to Operation and Maintenance Manual, "GPS Accuracy Mode - Set" for additional information.Blade Wear
As you operate the machine, the cutting edge of the blade wears away. This feature allows the measurement of the cutting edge to be updated.
Illustration 12 g01526151
Measure the blade wear regularly. Record the amount of wear in the software for the AccuGrade System. For instructions, Refer to Operation and Maintenance Manual, "Blade Wear - Set".Vertical Guidance
Verify or change the desired vertical guidance method. Refer to Operation and Maintenance Manual, "Vertical Guidance Method - Set" for additional information.The AccuGrade System examines the design surface from two points on the cutting edge of the blade. These two points are configurable by the operator. When a one point method is used, the system examines the design from two points that are 5.0 cm (2.0 inch) apart. Once a vertical guidance method is selected, the system examines the design directly above or below the two selected points. The system will then try to move the blade to those points on the design when the system is in Automatic mode. If overcut protection is turned on, two additional points are examined at the blade tips. This will keep the blade tips from digging into the design when the system is in automatic mode.
Table 1
Vertical Guidance Methods    
Method     Description    
1 Point Center     This method sets one vertical guidance point