COUPLING AS 3064349 - Caterpillar

Illustration 6 g01710913
Highlight the "Internet Protocol (IPv4) Network Mask" entry and click "Change".
Illustration 7 g01710914
Enter the "Subnet" mask value of "255.255.255.0" and click "OK".
Click "Yes" in order to program the PL1000E.
Illustration 8 g01710915
Highlight the "Internet Protocol (IPv4) Address"" entry and click "Change".
Illustration 9 g01710916
Enter the four parts of the IP address in the four fields according to the information that is provided by the network administrator. Click "OK".Note: If a PC is to be connected directly to the PL1000E via a crossover ethernet cable, then leave the IP configuration set to the default settings.
Click "Yes" in order to program the PL1000E.
In order to make the PL1000E changes effective, turn the key switch to the OFF position, then turn the key switch back to the ON position. The PL1000E is ready for direct connect use.Configuring a Stand - Alone Windows PC to Access the PL1000E Communication Module
Note: The PC must be equipped with a wired Ethernet adapter. If the PC is normally on a wired network, this procedure requires temporarily disconnecting the PC from the network in order to connect to the PL1000E.Perform the following steps in order to configure a Windows based PC that is not on a network to access the PL1000E.Note: A crossover ethernet cable is required in order to directly connect the network adapter port (RJ-45) of the PC to the network adapter port of the PL1000E without the use of a hub or switch.
Click "Start Menu".
Click "Control Panel".
Click the Internet Options (9) program.
Illustration 10 g01710918
Select the Connections tab (10) .
Illustration 11 g01404026
Click "LAN Settings" (11) .
Illustration 12 g01404032
Make a note of the current settings. Uncheck all checked boxes.
Click "OK".
Click "OK" again in order to close the Internet Properties window.
In the "Control Panel" click the "Network Connections" (12) .
Illustration 13 g01710920
Click Local Area Connection (13) .
Illustration 14 g01710921
In the Local Area Connection Status window click "Properties" (14).
Illustration 15 g01404040
In the box that is titled "This connection uses the following items:", scroll down the screen and then select "Internet Protocol (TCP/IP)" (15). Refer to Illustration 16.Note: There is a possibility that an ethernet adapter card has not installed on a Windows based PC that is not networked. If an ethernet adapter card has not installed, then the item, "Internet Protocol (TCP/IP)", will not appear in the list. In order to proceed with this type of connection, an ethernet adapter card must be installed or a different PC that is equipped with an ethernet adapter must be used.
Illustration 16 g01404064
Highlight "Internet Protocol (TCP/IP)" (16) .
Click "Properties" (17) .
Make a note of the current settings.
Select "Use the Following IP Address".
Illustration 17 g01404041
Enter the IP address in the form "192.168.1.10". Enter the "Subnet" mask as "255.255.255.0".
Click "OK".
Click "OK" on the Local Area Connection Properties window in order to close the window.