COUPLING AS 5043840 - Caterpillar

Table 1
Required Parts List
Item Qty New Part Number Part Name Former Part Number(1)
1 2 560-3608 Bracket 329-3664
2 4 560-3611 Screw 495-6147
(1) The former part number listed is for reference only and may differ.
Illustration 1 g06292621
(1) 560-3608 Bracket
(2) 560-3611 Screw
(A) 473-8879 Fastener locations (if required)
(B) 495-6148 Plate
(C) 515-9909 StrapEach machine has two brackets, they must be replaced in pairs.Note: The plate (B) shown in Illustration 1 goes under the bracket on the cab, not under the bracket on the door.If the existing fasteners are no longer usable, then use the four fasteners (A). To install the fasteners (A), use a drill bit and drill out the existing fasteners. Then install the new fasteners (A). Refer to Illustration 1 for the locations of the fasteners.Make sure that the brackets (1) are facing inward as shown in Illustration 1, and that the door opens approximately 90 degrees after the bracket installation.If the door opens more than 90 degrees, an updated door strap (C) may be required. Refer to Service Magazine , M0082392.The Service Magazine is available through the normal literature distribution system. The publication can also be found on the Caterpillar Service Information System (SIS).