COUPLING 5446010 - Caterpillar

Illustration 14 g01172074
Position for wheel tractor-scraper digital window (1) Machine originWheel Dozer
Illustration 15 g01172076
Position for wheel dozer digital window (1) Midpoint of the blade along the machine centerline.Adding a Gauge Window
The gauge window provides an operator with information about whether the machine is operating above grade, below grade, or within a specified tolerance of grade.Perform the following steps in order to add a gauge window.
Illustration 16 g01172077
Select grade tolerance
Press the "Alt" key in order to bring up the CAESultra menu. From the menu, select "Configuration". Then select "Gauge". The "Select Grade Tolerance" panel appears.
Enter a value in the "Grade Tolerance" box. The default value is 0.30 m (1.0 ft). In a grade plan window, this will show the color green for any terrain that is accurate to the design within 0.3 m (1.0 ft). Note that CAESultra cannot measure less than 152.4 mm (6.0 inches) accuracy.
Enter a value in the "Grade Range" box. The default value is 3.28 m. A grade range value that is three times the grade tolerance value is recommended in order to evenly represent fill (blue), grade (green), and cut (red) areas.
Click the "Apply" button in order to apply these values to the color range bar.
Under "Color Range", use the slider to adjust the color range. A darker red or blue indicates that the area needs more cutting and filling. A lighter red or blue indicates that the area is approaching grade.
Illustration 17 g01172078
The gauge window
Click "OK". The gauge window appears, filling the entire CAESultra screen.
Illustration 18 g01172079
The gauge window resized
Using the cursor, resize the gauge window to the desired resolution.Adjusting a Gauge Window
Once the gauge window has been configured, the values the gauge window displays can be adjusted by using the Gauge More and Gauge Less tools on the CAESultra toolbar.The gauge menu options can also be used in order to adjust the gauge window. The gauge menu is opened from the main menu.Adding a Profile Window
The profile window provides an operator with a cross-sectional view of the terrain.Perform the following steps in order to add a profile window.
Illustration 19 g01172081
Select profile parameters panel
Press the "Alt" key in order to bring up the CAESultra menu. From the menu, select "Configuration", then select "Profile". The "Select Profile Parameters" panel appears.
In the "No. of Points" box, enter the number of points that are to displayed along the x-axis.
In the "Height" box, enter the desired height of the profile in display units. Note that adjusting this value have no effect if "True Scale " is being used.
In the "Length" box, enter the desired length of the profile in display units.
Check or uncheck the "True Scale" and "Profile Along Heading" boxes.If "True Scale" is selected, then the proportion of the height to the width remains the same. Both the "Profile Thicker" and the "Profile Thinner" functions have no effect. If true scale is not selected, then the proportion of the height to the width can change. The "Profile Thicker" function increases the range of the vertical axis of the profile. The "Profile Thinner"