AVSPARE.COM
parts catalog

COUPLING, GEAR B137823 - Caterpillar



B137823 COUPLING, GEAR Caterpillar parts CB-414 COUPLING
Rating:
35
Alternative (cross code) number:
CAB137823
B13-7823
B137823
Caterpillar B137823 COUPLING, GEAR

Buy COUPLING, GEAR B137823 Caterpillar genuine, new aftermarket tractor parts with delivery
VIBRATORY COMPACTOR,

Compatible equipment models: B137823:

VIBRATORY COMPACTOR  CB-414   Caterpillar
Number on catalog scheme: 15
 
  For full view, you need register

Information:

diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1132 FMI 08 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure. Test Step 1. CHECK FOR POWER AT THE PWM THUMB WHEEL
Do not disconnect the harness connector from the joystick.
Turn the key start switch and the disconnect switch to the ON position.
At the back of the harness connector for the joystick, insert a 7X-1710 Multimeter Probe along the voltage supply wire M947-OR (contact 1).
Measure the voltage from contact 1 (wire M947-OR) to frame ground.Expected Result:The voltage is approximately 12 DCV.Results:
OK - The voltage is approximately 12 DCV. Proceed to Test Step 2.
NOT OK - The voltage is not approximately 12 DCV. The circuit is open. Repair: Repair the machine harness or replace the machine harness. Stop.Test Step 2. CHECK THE SIGNAL CIRCUIT OF THE PWM THUMB WHEEL OF THE LEFT JOYSTICK FOR THE CORRECT DUTY CYCLE.
Turn the key start switch and the disconnect switch to the OFF position.
At the back of the harness connector for the sensor, remove the 7X-1710 Multimeter Probe from contact 1 (wire M947-OR) and insert the probe along the signal wire M943-YL (contact 3).
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the ground wire M948-BR (contact 2).
Turn the disconnect switch and the key start switch to the ON position.
Monitor the duty cycle of the thumb wheel with the 146-4080 Digital Multimeter .
Without disconnecting the joystick or the hardware that is associated with the joystick from the machine, move the thumb wheel through the entire

Caterpillar parts catalog:

Caterpillar parts catalog
CB-414 VIBRATORY COMPACTOR 6KD00001-UP (MACHINE) POWERED BY 4239D ENGINE


Parts coupling Caterpillar catalog:

13810165 COUPLING, PIPE
CB-414, TSF-54, TSM-54
13810120 COUPLING, PIPE
PS-110, PS-130, PS-180
13810165 COUPLING, PIPE
CB-414, TSF-54, TSM-54
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.