COVER 0861661 - Caterpillar

Table 1
Required Tools
Tool Part Number Description Qty
A(1) 198-4234 Digital Indicator 1
B(1) 198-4236 Adapter Cable As 2
C(1) 198-4237 Pressure Sensor Gp 0-3500 kPa (0-500 psi) 2
D 348-5430 Multi-Tool Gp 1
E 110-6349 Fitting As 2
(1) Tool (A), Tool (B), and Tool (C) are part of the 198-4240 Digital Pressure Indicator Gp.
Drive the machine to a smooth, horizontal surface.
Illustration 1 g03160636
Move propel lever (1) to the NEUTRAL position.
Move parking brake switch (2) to the ON position.
Use throttle control switch (3) in order to operate the engine in ECO mode or in low idle. Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First,"Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
Move engine start switch (4) to the OFF position.
Illustration 2 g03160638
Unlock latch (5) and open engine compartment door (6) on the right side of the machine.
Illustration 3 g03160639
Remove ten bolts (7) and remove side panel (8) on the right side of the machine.
Illustration 4 g03160643
Mark the connectors, then disconnect solenoid electrical connections (9).
Assemble the tooling. Connect Tool (B) to Tool (C). Assemble two sets of Tool (B) and Tool (C).
Connect both sets of Tool (B) to Tool (A).
Illustration 5 g03160644
Remove the plugs from port "X1" (10) and port "X2" (11). Install one Tool