COVER 0959753 - Caterpillar

Illustration 41 g01320344
Install the two needle bearings in Location (X) by using Tooling (K). Install the inside needle bearing. Make sure that the needle bearing is flush with the inside surface of the case. Install the outside needle bearing. Make sure that the needle bearing makes contact with the bottom of the bore in the case.
Install the two needle bearings in Location (Y) by using Tooling (K). Install the inside needle bearing. Make sure that the needle bearing is flush with the inside surface of the case. Install the outside needle bearing. Make sure that the needle bearing is flush with the bottom of the counterbore in the case.
Install seal (82) by using Tooling (K). Make sure that the lip is toward the inside of the case and that the seal makes contact with the bottom of the counterbore. Put clean oil on the lip of the seal.
Illustration 42 g00321598
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install one lever (83) and shaft (84). Install one lever (85) and spring (86) .
Illustration 43 g00321623
Slide shaft (87) into the case. Slide levers (88) onto the shaft.
Illustration 44 g00321626
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install the bolts and nuts (90). Tighten the bolts to a torque of 35 4 N m (26 3 lb ft).
Install spring (89) .
Illustration 45 g01321137
Install two Tooling (B) and a suitable lifting device to transmission case (91). The weight of transmission case (91) is approximately 63 kg (140 lb). Install transmission case (91) .
Install the bolts that hold transmission case (91) .
Illustration 46 g00321723
Install bolts (93) that hold the bearing cage to transmission case (91) .
Coat the seals with clean oil on sleeves (92) and install the sleeves. If the seals are damaged or worn replace the seals with new seals.Note: Make sure that the O-ring seals are in position on the clutch housings before the hydraulic controls are installed. Put clean oil on the O-ring seals.
Illustration 47 g00321763
Position valve assembly (94) in the transmission. Install bolts (95). Tighten the bolts to a torque of 45 4 N m (33 3 lb ft).
Install tube (96) .
Install cover (97) and the bolts.
Put a small amount of clean oil on O-ring seals (98) and install the seals. If the seals are damaged or worn replace the seals with new seals.
Illustration 48 g00321766
Install pressure control valve (99) .
Install bolts (100). Tighten the bolts to a torque of 45 4 N m (33 3 lb ft).
Illustration 49 g01323836
Install the gasket, cover (101), bolts (102) and washers to the transmission case (91). If the gasket is damaged or worn replace the gasket with a new gasket.End By: Install the transmission and transfer gears. Refer to Disassembly and Assembly, "Transmission and Transfer Gears - Install".