COVER 1117878 - Caterpillar

Disassembly Procedure
Start By:
Remove the gear pump. Refer to Disassembly and Assembly, "Gear Pump - Remove".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put alignment marks on all sections of the pump for ease of assembly.
Illustration 1 g00731096
Remove O-ring (1) .
Illustration 2 g00731097
Remove retaining ring (2) and seal (3) .
Illustration 3 g00731098
Remove four bolts (4) and washers. Remove plate (5) and remove gear pump (6). Gear pump (6) is the fan pump.
Illustration 4 g00731101
Remove O-ring (7). Remove back up ring (8). Remove O-ring (9) .
Illustration 5 g00731105
Rotate gear pump (6) to the other side.
Remove seal (10). Remove back up seal (11) and remove O-ring (12) .
Illustration 6 g00731108
Remove plate (13) .
Illustration 7 g00731113
Remove seal (14). Remove back up seal (15) and remove O-ring (16) .
Remove plate (17) .
Illustration 8 g00731115
Remove seal (18). Remove back up seal (19) and remove O-ring (20) .