COVER 1384811 - Caterpillar

Table 1
Complete List of Available Parameters        
ID Number     Tool Parameter     Notes    
001     Name of the Tool        
002     Upper limit of the engine speed dial during tool operation (1 - 10)     Normally, these parameters are not changed.    
003     ON/OFF of the above function during tool operation    
004     Enable the stop function or Disable the stop function of the underspeed control function.    
005     "ENABLE" or "DISABLE" of combined flow with 2 pumps.        
101     This is the flow that is required for the tool.     These parameters are not used on System 5.    
102     Additional flow during the simultaneous operation of hydraulic functions    
103     Primary pressure    
201     Flow for spool 2        
202     Additional flow during simultaneous operation of the tool and the other actuator in spool 2    
203     Pressure for the auxiliary control valve    
301     Flow for spool 3    
302     Additional flow during the simultaneous operation of the tool and the other function in spool 3    
303     Pressure for Spool 3    
401     Flow for spool 4    
402     Additional flow during the simultaneous operation of the tool and the other function in spool 4    
403     Pressure for Spool 4    Programming The Five Tools
In order to program any of the parameters of the machine, first enter "Service Mode" on the monitor. This procedure is described in full in Testing and Adjusting, "Service Mode - Enter" for the Tool Control System. After entering the password for the service mode, the following screen will be displayed on the monitor:
Illustration 1 g00988909
Illustration 2 g00685772
Monitor Panel (7) Up key (8) Left key (9) Right key (10) Down key (11) Cancel key (12) Menu key (13) OK key (14) keyUse down key (10) in order to highlight line 2. Use right key (9) and scroll until "CONFIGURATION" is displayed on the monitor. If the right key (9) is pressed again, "TOOL PROGRAM" will be displayed on the monitor. All of the parameters of the machine will be programmed under these two headings. The parameters that are available for programming are shown in the following illustration:
Illustration 3 g00993041
Illustration 4 g00779463
After you reach the "TOOL PROGRAM" screen, press down key (10) in order to highlight the third line. The left side of the line ("TOOL#1") is initially highlighted. This is shown in illustration 4. Press left key (8) or right key (9) in order to scroll through the five tools that are available. After you reach the desired tool, press menu key (13) in order to highlight the right side of the line. This is shown in illustration 5.
Illustration 5 g00779470
In illustration 5, "TOOL#1" is the tool that is being programmed. The value for parameter 001 is on the fourth line. Press down key (10) in order to change the fourth line. If