COVER 1439288 - Caterpillar

Remove bolts (5). Remove panel assembly (6).
Illustration 4 g01232940
Remove bolts (7) and remove bolts (8) from bonnet (9).
Remove bonnet (9).
Illustration 5 g01232937
Remove bolts (10) from both ends of engine oil cooler (11). Remove engine oil cooler (11).
Illustration 6 g01232927
Remove gaskets (12) and remove O-ring seal (13) from bonnet (9).
Illustration 7 g01232926
Remove adapter (14) from engine oil cooler (11). Remove O-ring seals (15) from adapter (14).Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 369-9451 O-Ring Assembly Compound 1
B 5H-2471 Adhesive 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Check the condition of the O-ring seals. If the O-ring seals are worn or damaged, use new parts for replacement. Always replace used gaskets with new gaskets.
Illustration 8 g01232926
Apply Tooling (A) to the bore of engine oil cooler (11) and O-ring seals (15).
Install O-ring seals (15) on adapter (14).
Install adapter (14) into engine oil cooler (11).
Illustration 9 g01232937
Position engine oil cooler (11) and install bolts (10).
Illustration 10 g01232927
Apply Tooling (B) to the contact surface of bonnet (9) and install gaskets (12). Apply Tooling (A) onto O-ring seal (13) and install O-ring seal (13) onto bonnet (9).
Illustration 11 g01232940
Position bonnet (9). Install bolts (8) and install bolts (7).Note: Lightly tighten bolts (8) and bolts (7) before applying torque.
Illustration 12 g01232862
Position panel assembly (6) and install bolts (5).
Illustration 13 g01232815
Position baffles (4) and install bolts (3).
Illustration 14 g01232814
Close grill assemblies (2). Install bolts (1).
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".