COVER AS 1462904 - Caterpillar

Installation Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00588937
Remove screws (1). Remove plate (2) from the machine.
Illustration 2 g00588941
Disconnect wiring harness (3) .
Illustration 3 g00588947
Remove knob (4) from the control lever. Raise switches (5) and (6) from the dash panel. Disconnect the wiring harnesses from switches (5) and (6) .
Illustration 4 g00588949
Remove bolts (7) and the washers. This will free up three-point hitch position sensor (8) .
Illustration 5 g00588954
Disconnect wires (10) from lockout switch (9). Remove the rotary position sensor and the wiring harness as a unit.
Illustration 6 g00588949
Remove bolts (7) and the washers. This will free up three-point hitch position sensor (8) .Installation Procedure
Illustration 7 g00588954
Install the rotary position sensor and the wiring harness as a unit back to the original location. Connect wires (10) to lockout switch (9).
Illustration 8 g00588947
Connect the wiring harnesses to switches (5) and (6). Lower switches (5) and (6) to the dash panel. Install knob (4) to the control lever.
Illustration 9 g00588941
Connect wiring harness (3) .
Illustration 10 g00588937
Install plate (2) to the machine. Install screws (1) .