COVER AS 1469002 - Caterpillar

Ether
Do not spray ether into an engine when you use thermal starting aid to start the engine.Ether is poisonous and flammable. Inhaling ether vapors can cause personal injury. Do not allow ether to contact your skin repeatedly. Use ether only in well ventilated areas. Do not smoke while you replace ether cylinders. Use ether carefully to avoid fires. Do not store ether cylinders in living areas or in the operator's compartment.Do not store ether cylinders in direct sunlight or at temperatures above 49 °C (120 °F). Discard ether cylinders in an approved place. Do not puncture ether cylinders. Do not burn ether cylinders. Keep ether cylinders out of the reach of unauthorized personnel.Lines, Tubes and Hoses
Do not bend high pressure lines. Do not strike high pressure lines. Do not install bent lines, bent tubes, or bent hoses. Do not install damaged lines, damaged tubes, or damaged hoses.Repair loose lines, loose tubes, and loose hoses. Repair damaged lines, damaged tubes, and damaged hoses. Leaks can cause fires. See your Caterpillar dealer for repair or for replacement parts.Check lines, tubes and hoses carefully. Do not use your bare hand to check for leaks. Use a board or cardboard to check for leaks. See Operation and Maintenance Manual, "General Hazard Information" for more details. Tighten all connections to the recommended torque.Replace the parts if any of the following conditions are present:
End fittings that are damaged or leaking
Outer coverings that are chafed or cut
Wire shields that are exposed
Outer coverings that are ballooning
Flexible part of the hoses that are kinked
Outer covers that have embedded armoring
End fittings that are displacedMake sure that all clamps, guards, and heat shields are installed correctly. During machine operation, this will help prevent vibration, the rubbing against other parts, and excessive heat.