COVER GP-VALVE MECHANISM 2462582 - Caterpillar

Checking Face Runout Of The Flywheel1. Install the dial indicator as shown. Put a force on the flywheel toward the rear.2. Set the dial indicator to read 0.0 mm (.00 in).3. Turn the flywheel and read the indicator every 90°. Put a force on the flywheel to the rear before each reading.4. The difference between the lower and higher measurements taken at all four points must not be more than: Flywheel without BrakeSaver ... 0.15 mm (.006 in)Flywheel with BrakeSaver ... 0.30 mm (.012 in)This is the maximum permissible face runout (axial eccentricity) of the flywheel.Bore Runout (radial eccentricity) of the Flywheel:
Checking Flywheel Bore1. Install the dial indicator (3) and make an adjustment of the universal attachment (4) so it makes contact as shown.2. Set the dial indicator to read 0.0 mm (.00 in).3. Turn the flywheel and read the indicator every 90°.4. The difference between the lower and higher measurements taken at all four points must not be more than: Flywheel without BrakeSaver ... 0.15 mm (.006 in)Flywheel with BrakeSaver ... 0.25 mm (.010 in)
Checking Flywheel Clutch Pilot Bearing Bore5. Runout (eccentricity) of the bore for the pilot bearing for the flywheel clutch, must not exceed: Flywheel without BrakeSaver ... 0.13 mm (.005 in)Flywheel with BrakeSaver ... 0.25 mm (.010 in)