COVER-PUMP 2463253 - Caterpillar

Removal Procedure
Start By:
Remove the after cooler. Refer to Disassembly and Assembly, "After Cooler - Remove and Install".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Drain the coolant into a suitable container for storage or disposal. Refer to the Operation and Maintenance Manual.
Illustration 1 g00915389
Disconnect tube assembly (1) .
Illustration 2 g00915391
Disconnect elbow (2) . Disconnect tube assemblies (3) on both turbochargers.
Illustration 3 g01213959
Disconnect harness assembly (4) .
Remove clamp (5) .
Remove cable straps (6) on the harness assembly for sender (7) .
Illustration 4 g00915412
Remove sender (8) from manifold (9) .
Illustration 5 g00915416
Typical Example
Attach a suitable lifting device to manifold (9) .
Illustration 6 g00915418
Remove bolts (10) from manifold (9) .
Remove manifold (9) . The weight of manifold (9) is approximately 227 kg (500 lb).Installation Procedure
Illustration 7 g00915416
Typical Example
Attach a suitable lifting device to manifold (9) and place manifold (9) into position. The weight of manifold (9) is approximately 227 kg (500 lb).
Illustration 8 g00915418
Install bolts (10) into manifold (9) .
Illustration 9 g00915412
Install sender (8) into manifold (9) .
Illustration 10 g01213959
Connect harness assembly (4) .
Install clamp (5) on the sender.
Install cable straps (6) onto the harness assembly for sender (7) .
Illustration 11 g00915391
Connect tube assemblies (3) on both turbochargers. Connect elbow (2) .
Illustration 12 g00915389
Connect tube assembly (1) .
Fill with coolant. Refer to the Operation and Maintenance Manual.End By: Install the aftercooler. Refer to Disassembly and Assembly, "Aftercooler - Remove and Install".