COVER GP-ACCESS 2625868 - Caterpillar

Illustration 12 g06214803
(8) Pin
Insert pin (8) through the bucket tip.
Illustration 13 g06214807
Place the Pin-Master over the bucket tips so that the pin will fit into the counterbore of the pin holder (9).
Strike the Pin-Master with a hammer at the back of the tool (4) to insert the pin.
Slide pin holder (9) away from the pin and rotate the tool slightly to align pin setter (10) with the pin.
Illustration 14 g06214812
Final assembly of pin into bucket tip
Strike the end of the tool until the pin is fully inserted.Bucket Tips (Cat® Advansys) - If Equipped
Illustration 15 g06214790
(1) Usable tip
(2) Replaceable bucket tip
(3) Overworn tipCheck the bucket tips for wear. If the bucket tip has a hole, replace the bucket tip.Removal
Illustration 16 g03830653
(1) Bucket Tip
(2) Retainer
(3) Adapter
(4) Compression Sleeve
Use a 1/2" ratchet and rotate the retainer (2) 180 degrees to the unlocked position.
Remove the bucket tip (1) from adapter (3).
Clean adapter (3).Installation
Clean the adapter and the area around the latch, if necessary.
Install the new bucket tip (1) onto the adapter (3).
Illustration 17 g03832654
Use a 1/2" ratchet to rotate the retainer (2) 180 degrees to the locked position.Side Cutters
Illustration 18 g06214814
Bucket With Side Cutters
Remove the mounting bolts and the side cutters (11).
Clean the mounting surface of the side plate on the bucket and of the side cutter. Remove any burrs or protrusions on the mating surfaces.
Illustration 19 g06214887
(12) Shear ledge on a side cutter
(13) Side plate on a bucket
(B) 0.0 mm (0.0 inch)Note: Some side cutters may be rotated for additional wear.
Install the side cutter.Note: Certain bolts may require thread compound.
Hand tighten the bolts.
Make sure that there is not a gap between the side plate on the bucket and the shear ledge on the side cutter.
Torque the mounting bolts to the correct specification.Side Protectors (If Equipped)
Inspect the wear of the side protector. When too much wear is present, replace the protector.
Illustration 20 g06219766
Illustration 21 g06219767
(14) Side plate
(15) Retainer
(16) Side protector
(17) Pin
(18) Shim
Hit pin (17) from the side of the bucket without the retainer to remove side protector (16) from side plate (14).
Clean side protector (16), pin (17), retainer (15), and side plate (14) before installation.Note: Lateral clearance between the side plate and the side protector should not exceed 1 mm (0.04 inch). Shims (18) may be required to decrease the lateral clearance which will decrease movement. Install the shims between the side plate and the side protector on the opposite side of the retainer.
Put retainer (15) in side plate (14).
Align two pin holes of the new protector and the side plate. Hit the pin from the retainer side of the bucket.Note: If the pin and/or the retainer are worn, replace the pin and/or the retainer.