COVER 2P3589 - Caterpillar

Specifications
Table 1
Implement Cycle Times
Description Specification Actual
Raise Cycle Time 950M 5.9 +/- 0.5 sec
Raise Cycle Time 962M 6.0 +/- 0.5 sec
Lower Cycle Time 950M 3.1 + 1.0 / - 0.5 sec
Lower Cycle Time 962M 3.7 + 1.0 / - 0.5 sec
Float Cycle Time 950M 2.3 + 1.0 / - 0.5 sec
Float Cycle Time 962M 2.7 + 1.0 / - 0.5 sec
Dump Cycle Time 950M 2.0 +/- 0.5 sec
Dump Cycle Time 962M 2.0 +/- 0.5 sec
Rack Back Cycle Time 950M 2.5 +/- 0.5 sec
Rack Back Cycle Time 962M 2.6 +/- 0.5 sec Introduction
The speed of the implements is affected by the amount of oil flow that is produced by the implement pump. Check the implement cycle times in order to determine if there may be a problem with the implement pump.The implement cycle time can be checked in order to verify a complaint about slow implement speed. This test will also help to determine whether all functions are slow or only one function is slow.Test Preparation
Warm the hydraulic oil to normal operating temperature of 62° 8°C (143.6° 14.4°F).
Move the machine to a smooth, level surface. Move away from working machines and personnel. Lower the bucket to the ground.
Allow only one operator on the machine. Keep all personnel away from the machine or in the view of the operator.
Place the transmission into neutral.
Engage the parking brake.
Place the steering frame lock in the LOCKED position.
Enable hydraulic service mode.Note: Insure pilot pressure is correct before performing any of the cycle time tests. Refer to Testing and Adjusting, "Pilot Pressure - Test" for your machine.Note: The cycle time tests may also be performed using Cat ET.Test Procedure
Raise Cycle Time
Tilt back the bucket. Lower the lift linkage to the full LOWER position.
Run the engine at high idle.
Move the lift control lever to the full RAISE position. Hold the lift control lever in this position until the lift cylinder reaches the end of travel.
Record the amount of time that is required for the work tool to travel from the ground to the full RAISE position.Note: Refer to Table 1 for specifications.Lower Cycle Time
Tilt back the bucket. Raise the lift linkage to the full RAISE position.
Run the engine at high idle.
Move the lift control lever to the full LOWER position. Hold the lift control lever in this position until the lift cylinder reaches the end of travel.
Record the amount of time that is required for the work tool to travel down to the full LOWER position.Note: Refer to Table 1 for specifications.Float Cycle Time
Tilt back the bucket. Raise the lift linkage to the full RAISE position.
Push the joystick into the FLOAT position and allow the linkage to drop on via gravity.
Record the amount of time that is required for the work tool to travel down to the full LOWER position.Note: Refer to Table 1 for specifications.Dump Cycle Time
Position the lift linkage to the MID LIFT position.
Position the bucket to the full TILT BACK position.
Run the engine at high idle.
Raise the linkage to the mid