COVER GP-CYLINDER HEAD 3188038 - Caterpillar

1. Remove nut (2) and disconnect rod assembly (1) from the lever. 2. Remove cotter pin (8) and washer. Disconnect yoke (6) from the lever.3. Remove spring (4).4. Remove cotter pin and pin (5). Remove collar (7). Remove lever assembly (3). 5. Remove three bolts (10). Remove governor pedal (9) and base assembly as a unit.Install Governor Pedal Group
1. Put governor pedal (1) and base assembly in position. Install the bolts that hold it. 2. Put lever assembly (3) in position. Install the collar, pin and cotter pin that hold it on the shaft.3. Install the spring on the lever assembly.4. Connect yoke (4) to the lever assembly.5. Connect rod assembly (2) to the lever assembly.6. Make an adjustment to the pedal assembly so it is at a 66° 3° angle with the floor when the engine governor shaft is in the "OFF" position.Disassemble Governor Pedal Group
start by:a) remove governor pedal group 1. Remove cotter pin and washer (1) from the shaft.2. Remove plug (2) from the base assembly. 3. Loosen bolt (4). Remove base assembly and lever (3) from the pedal assembly. 4. Remove screw (7). Remove shaft (6) from pedal (5). 5. Remove bearing and bushing (8) from base assembly (9) with tooling (A). 6. Remove rod assembly (11) from lever (12).7. Remove bearings (10) from the lever with tooling (A).Assemble Governor Pedal Group
1. Install bearings in lever (1) with tooling (A). Install one bearing in each end of the lever even with the surface of the lever.2. Make an adjustment to the length of the rod assembly so the distance between the centerlines of the rod ends is 85 1 mm (3.346 .039 in.). 3. Install rod assembly (2) on the lever. 4. Use tooling (A) to install bushing (4) even with the surface of base (3). Install bearing on the opposite side of the base with tooling (A) even with the surface of the base. 5. Install shaft (6) in pedal (5). Put 9M3710 Anti-Seize Compound on the threads and install screw (7) in the pedal to hold shaft in position.6. Install base assembly and lever (8) on the shaft as shown. Lever (8) and pedal (5) must be at a 140° 3° angle as shown when the lever is installed on the shaft. 7. Install plug (11) in the base. 8. Install washer (10) and cotter pin (9) on the shaft.end by:a) install governor pedal group