COVER-SWITCH 3237233 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00521562
Position compression brake housing (4) on the studs.
Install nuts (1) and tighten to a torque of 80 15 N m (60 11 lb ft).
Install bolt (3) and tighten to a torque of 55 10 N m (41 7 lb ft).
Connect harness assembly (2) to the solenoid valve on the compression brake.Note: The valve lash must be adjusted before adjusting the slave piston lash.
Adjust the valve lash. Refer to Testing and Adjusting, "Air Inlet and Exhaust System".
Adjust the slave piston lash. Refer to Testing and Adjusting, "Compression Brake".End By: Install the valve mechanism covers. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".