COVER 3295087 - Caterpillar

Disassembly Procedure
Start By:
Remove the pilot valve (stabilizer) from the cab. Refer to Disassembly and Assembly, "Pilot Valve (Stabilizer) - Remove".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes.
Illustration 1 g01529541
Illustration 2 g01529560
Remove bolts (1) and bolts (3) .
Remove lever kits (2) and (4) .
Remove plate (5) from valve body (6) .
Illustration 3 g00768383
Remove screws (7) .
Reposition plate (8) in order to allow access to the retaining pin.
Illustration 4 g00768385
Remove retaining pin (9) .
Illustration 5 g00768388
Remove lever (10) .
Repeat Step 4 through Step 7 in order to disassemble the other lever kit.
Illustration 6 g01971535
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove plunger (11), regulator (12), spring (13), socket (14) and spring (15) .Note: Note the location of plungers (11) during the disassembly procedure.
Repeat Step 9 for the remaining ports.