COVER-YM 3960658 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5P-4758 Internal Pliers 1
B 1P-1842 Bearing Puller Adapter 1
9S-5559 Stud 1
6V-3160 Hydraulic Cylinder 1
6V-9061 Manual Pump Group 1
1P-543 Nut 1
1A-1935 Washer 1
3K-5234 Washer 1
1P-1837 Bearing Puller Adapter 1
FT-1645 Spacer 1
C 1P-1842 Bearing Puller Adapter 1
9S-5559 Stud 1
6V-3160 Hydraulic Cylinder 1
6V-9061 Manual Pump Group 1
1P-543 Nut 1
1A-1935 Washer 1
3K-5234 Washer 1
1P-1835 Bearing Puller Adapter 1
D 1P-510 Driver Group 1 Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage components. All disassembly and all assembly procedures must be performed on a clean work surface and in a clean hydraulic area. Keep cleaned parts covered and protected at all times.
Illustration 1 g00743086
Illustration 2 g00743088
Use Tooling (B) and install one snap ring in the end of the equalizer bar.
Pack bearings (4) with 5P-0960 Multipurpose Grease.
Install bearing (4) in the equalizer bar until the bearing makes contact with the snap ring. If necessary, use Tooling (D) to install the bearing.
Install the remaining snap ring with Tooling (B).
The seal bores in the equalizer bar must be clean and free of grease, oil and old adhesive.
Put 7M-7456 Bearing Mount on the surfaces of the equalizer bar that make contact with seals (3). Install seals (3) in the equalizer bar.
Illustration 3 g00743089
Illustration 4 g00743090
Use Tooling (E) and install two center pin bearings (2) until the center pin bearings are 11 1 mm (0.43 0.04 inch) below the surface of the equalizer bar. The inside diameter of the bearings must be 63.687 0.084 mm (2.5074 0.0033 inch) after installation.
The seal bores must be clean and free of grease, oil and old adhesive.
Put 7M-7456 Bearing Mount on the seal bore of the equalizer bar.
Use Tooling (F), and install seals (1) in the equalizer bar with the lip of the seals toward the outside, as shown. Put clean SAE 30W oil on the lips of the seals. End By:
Install the equalizer bar. Refer to Disassembly and Assembly, "Equalizer Bar - Install".